[ 0.997387] pci 0000:00:03.0: BAR 0 [mem 0x00000000-0x00ffffff pref] [ 0.997406] pci 0000:00:03.0: BAR 2 [mem 0x00000000-0x00000fff] [ 0.997431] pci 0000:00:03.0: ROM [mem 0x00000000-0x00007fff pref] [ 0.997449] pci 0000:00:03.0: enabling Extended Tags [ 0.999375] pci 0000:00:03.0: BAR 0 [mem 0x40000000-0x40ffffff pref]: assigned [ 0.999556] pci 0000:00:03.0: ROM [mem 0x41000000-0x41007fff pref]: assigned [ 0.999649] pci 0000:00:01.0: BAR 4 [mem 0x400000000-0x400003fff 64bit pref]: assigned [ 0.999716] pci 0000:00:02.0: BAR 0 [mem 0x400004000-0x400007fff 64bit]: assigned [ 0.999758] pci 0000:00:01.0: BAR 1 [mem 0x41008000-0x41008fff]: assigned [ 0.999772] pci 0000:00:03.0: BAR 2 [mem 0x41009000-0x41009fff]: assigned [ 0.999798] pci 0000:00:01.0: BAR 0 [io 0x0020-0x003f]: assigned [ 1.000080] pci_bus 0000:00: resource 4 [io 0x0000-0xffff] [ 1.000111] pci_bus 0000:00: resource 5 [mem 0x40000000-0x7fffffff] [ 1.000122] pci_bus 0000:00: resource 6 [mem 0x400000000-0x7ffffffff] [ 1.000923] pci 0000:00:02.0: enabling device (0000 -> 0002) [ 1.006961] virtio-pci 0000:00:01.0: enabling device (0000 -> 0003) [ 1.011580] Serial: 8250/16550 driver, 4 ports, IRQ sharing disabled [ 1.023681] printk: legacy console [ttyS0] disabled [ 1.026838] 10000000.serial: ttyS0 at MMIO 0x10000000 (irq = 13, base_baud = 230400) is a 16550A [ 1.028710] printk: legacy console [ttyS0] enabled [ 1.093519] printk: legacy console [hvc0] enabled [ 1.095659] bochs-drm 0000:00:03.0: enabling device (0000 -> 0002) [ 1.101175] [drm] Found bochs VGA, ID 0xb0c5. [ 1.101706] [drm] Framebuffer size 16384 kB @ 0x40000000, mmio @ 0x41009000. [ 1.107370] [drm] Found EDID data blob. [ 1.112618] [drm] Initialized bochs-drm 1.0.0 for 0000:00:03.0 on minor 0 [ 1.146618] Console: switching to colour frame buffer device 160x50 [ 1.150971] bochs-drm 0000:00:03.0: [drm] fb0: bochs-drmdrmfb frame buffer device [ 1.170265] brd: module loaded [ 1.171532] virtio_blk virtio1: 1/0/0 default/read/poll queues [ 1.178868] virtio_blk virtio1: [vda] 765816 512-byte logical blocks (392 MB/374 MiB) [ 1.195526] xhci_hcd 0000:00:02.0: xHCI Host Controller [ 1.196865] xhci_hcd 0000:00:02.0: new USB bus registered, assigned bus number 1 [ 1.200864] xhci_hcd 0000:00:02.0: hcc params 0x00087001 hci version 0x100 quirks 0x0000000000000010 [ 1.203797] xhci_hcd 0000:00:02.0: xHCI Host Controller [ 1.204447] xhci_hcd 0000:00:02.0: new USB bus registered, assigned bus number 2 [ 1.205198] xhci_hcd 0000:00:02.0: Host supports USB 3.0 SuperSpeed [ 1.212465] hub 1-0:1.0: USB hub found [ 1.213411] hub 1-0:1.0: 4 ports detected [ 1.217354] usb usb2: We don't know the algorithms for LPM for this host, disabling LPM. [ 1.219159] hub 2-0:1.0: USB hub found [ 1.219720] hub 2-0:1.0: 4 ports detected [ 1.224589] goldfish_rtc 101000.rtc: registered as rtc0 [ 1.225422] goldfish_rtc 101000.rtc: setting system clock to 2025-05-21T07:39:20 UTC (1747813160) [ 1.228544] device-mapper: ioctl: 4.48.0-ioctl (2023-03-01) initialised: dm-devel@lists.linux.dev [ 1.230982] usbcore: registered new interface driver usbhid [ 1.231332] usbhid: USB HID core driver [ 1.231966] riscv-pmu-sbi: SBI PMU extension is available [ 1.232773] riscv-pmu-sbi: 16 firmware and 18 hardware counters [ 1.233159] riscv-pmu-sbi: Perf sampling/filtering is not supported as sscof extension is not available [ 1.237156] u32 classifier [ 1.237523] input device check on [ 1.237888] Actions configured [ 1.241838] NET: Registered PF_INET6 protocol family [ 1.249140] Segment Routing with IPv6 [ 1.249779] In-situ OAM (IOAM) with IPv6 [ 1.250781] sit: IPv6, IPv4 and MPLS over IPv4 tunneling driver [ 1.254102] NET: Registered PF_PACKET protocol family [ 1.255122] Bridge firewalling registered [ 1.256516] l2tp_core: L2TP core driver, V2.0 [ 1.257062] Key type dns_resolver registered [ 1.257900] NET: Registered PF_VSOCK protocol family [ 1.270919] registered taskstats version 1 [ 1.284278] Key type .fscrypt registered [ 1.284767] Key type fscrypt-provisioning registered [ 1.289645] Btrfs loaded, zoned=no, fsverity=no [ 1.309810] Key type encrypted registered [ 1.311351] printk: legacy console [netcon0] enabled [ 1.311926] netconsole: network logging started [ 1.352532] IP-Config: Complete: [ 1.353087] device=eth0, hwaddr=52:54:00:12:34:0e, ipaddr=192.168.7.14, mask=255.255.255.0, gw=192.168.7.13 [ 1.354231] host=192.168.7.14, domain=, nis-domain=(none) [ 1.354903] bootserver=255.255.255.255, rootserver=255.255.255.255, rootpath= [ 1.354967] nameserver0=8.8.8.8 [ 1.360047] clk: Disabling unused clocks [ 1.365579] md: Waiting for all devices to be available before autodetect [ 1.366369] md: If you don't use raid, use raid=noautodetect [ 1.367100] md: Autodetecting RAID arrays. [ 1.367633] md: autorun ... [ 1.367970] md: ... autorun DONE. [ 1.417514] EXT4-fs (vda): mounted filesystem da124d56-3e47-4ca1-8824-f4fa86879e08 r/w with ordered data mode. Quota mode: disabled. [ 1.419513] VFS: Mounted root (ext4 filesystem) on device 253:0. [ 1.422594] devtmpfs: mounted [ 1.468655] usb 1-1: new high-speed USB device number 2 using xhci_hcd [ 1.516068] Freeing unused kernel image (initmem) memory: 2300K [ 1.517472] Run /sbin/init as init process INIT: version 3.14 booting [ 1.622978] input: QEMU QEMU USB Tablet as /devices/platform/soc/30000000.pci/pci0000:00/0000:00:02.0/usb1/1-1/1-1:1.0/0003:0627:0001.0001/input/input0 [ 1.626167] hid-generic 0003:0627:0001.0001: input: USB HID v0.01 Mouse [QEMU QEMU USB Tablet] on usb-0000:00:02.0-1/input0 [ 1.748404] usb 1-2: new high-speed USB device number 3 using xhci_hcd [ 1.917447] input: QEMU QEMU USB Keyboard as /devices/platform/soc/30000000.pci/pci0000:00/0000:00:02.0/usb1/1-2/1-2:1.0/0003:0627:0001.0002/input/input1 [ 1.979789] hid-generic 0003:0627:0001.0002: input: USB HID v1.11 Keyboard [QEMU QEMU USB Keyboard] on usb-0000:00:02.0-2/input0 Starting udev [ 2.286971] udevd[131]: starting version 3.2.14 [ 2.364209] udevd[133]: starting eudev-3.2.14 [ 2.837205] EXT4-fs (vda): re-mounted da124d56-3e47-4ca1-8824-f4fa86879e08 r/w. Quota mode: disabled. INIT: Entering runlevel: 5 Configuring network interfaces... ip: RTNETLINK answers: File exists Starting OpenBSD Secure Shell server: sshd generating ssh ECDSA host key... done. Starting syslogd/klogd: done Poky (Yocto Project Reference Distro) 5.2 qemuriscv64 /dev/hvc0 qemuriscv64 login: