[ 0.853520] pci 0000:00:03.0: BAR 0 [mem 0x00000000-0x00ffffff pref] [ 0.853539] pci 0000:00:03.0: BAR 2 [mem 0x00000000-0x00000fff] [ 0.856106] pci 0000:00:03.0: ROM [mem 0x00000000-0x00007fff pref] [ 0.856143] pci 0000:00:03.0: enabling Extended Tags [ 0.857997] pci 0000:00:03.0: BAR 0 [mem 0x40000000-0x40ffffff pref]: assigned [ 0.858177] pci 0000:00:03.0: ROM [mem 0x41000000-0x41007fff pref]: assigned [ 0.858261] pci 0000:00:01.0: BAR 4 [mem 0x400000000-0x400003fff 64bit pref]: assigned [ 0.858328] pci 0000:00:02.0: BAR 0 [mem 0x400004000-0x400007fff 64bit]: assigned [ 0.858367] pci 0000:00:01.0: BAR 1 [mem 0x41008000-0x41008fff]: assigned [ 0.858380] pci 0000:00:03.0: BAR 2 [mem 0x41009000-0x41009fff]: assigned [ 0.858404] pci 0000:00:01.0: BAR 0 [io 0x0020-0x003f]: assigned [ 0.858615] pci_bus 0000:00: resource 4 [io 0x0000-0xffff] [ 0.858638] pci_bus 0000:00: resource 5 [mem 0x40000000-0x7fffffff] [ 0.858648] pci_bus 0000:00: resource 6 [mem 0x400000000-0x7ffffffff] [ 0.859375] pci 0000:00:02.0: enabling device (0000 -> 0002) [ 0.864856] virtio-pci 0000:00:01.0: enabling device (0000 -> 0003) [ 0.868782] Serial: 8250/16550 driver, 4 ports, IRQ sharing disabled [ 0.884201] printk: legacy console [ttyS0] disabled [ 0.887197] 10000000.serial: ttyS0 at MMIO 0x10000000 (irq = 13, base_baud = 230400) is a 16550A [ 0.888737] printk: legacy console [ttyS0] enabled [ 0.982616] printk: legacy console [hvc0] enabled [ 0.985164] bochs-drm 0000:00:03.0: enabling device (0000 -> 0002) [ 0.996735] [drm] Found bochs VGA, ID 0xb0c5. [ 0.997453] [drm] Framebuffer size 16384 kB @ 0x40000000, mmio @ 0x41009000. [ 1.009233] [drm] Found EDID data blob. [ 1.022710] [drm] Initialized bochs-drm 1.0.0 for 0000:00:03.0 on minor 0 [ 1.112357] Console: switching to colour frame buffer device 160x50 [ 1.128807] bochs-drm 0000:00:03.0: [drm] fb0: bochs-drmdrmfb frame buffer device [ 1.181774] brd: module loaded [ 1.183504] virtio_blk virtio1: 1/0/0 default/read/poll queues [ 1.194175] virtio_blk virtio1: [vda] 692928 512-byte logical blocks (355 MB/338 MiB) [ 1.228417] xhci_hcd 0000:00:02.0: xHCI Host Controller [ 1.229969] xhci_hcd 0000:00:02.0: new USB bus registered, assigned bus number 1 [ 1.235425] xhci_hcd 0000:00:02.0: hcc params 0x00087001 hci version 0x100 quirks 0x0000000000000010 [ 1.239609] xhci_hcd 0000:00:02.0: xHCI Host Controller [ 1.240382] xhci_hcd 0000:00:02.0: new USB bus registered, assigned bus number 2 [ 1.241156] xhci_hcd 0000:00:02.0: Host supports USB 3.0 SuperSpeed [ 1.250890] hub 1-0:1.0: USB hub found [ 1.252174] hub 1-0:1.0: 4 ports detected [ 1.257013] usb usb2: We don't know the algorithms for LPM for this host, disabling LPM. [ 1.259759] hub 2-0:1.0: USB hub found [ 1.260426] hub 2-0:1.0: 4 ports detected [ 1.266874] goldfish_rtc 101000.rtc: registered as rtc0 [ 1.268446] goldfish_rtc 101000.rtc: setting system clock to 2025-05-25T21:32:03 UTC (1748208723) [ 1.272523] device-mapper: ioctl: 4.48.0-ioctl (2023-03-01) initialised: dm-devel@lists.linux.dev [ 1.275752] usbcore: registered new interface driver usbhid [ 1.279587] usbhid: USB HID core driver [ 1.280970] riscv-pmu-sbi: SBI PMU extension is available [ 1.282832] riscv-pmu-sbi: 16 firmware and 18 hardware counters [ 1.284090] riscv-pmu-sbi: Perf sampling/filtering is not supported as sscof extension is not available [ 1.289771] u32 classifier [ 1.290229] input device check on [ 1.290875] Actions configured [ 1.293355] NET: Registered PF_INET6 protocol family [ 1.301915] Segment Routing with IPv6 [ 1.302506] In-situ OAM (IOAM) with IPv6 [ 1.303484] sit: IPv6, IPv4 and MPLS over IPv4 tunneling driver [ 1.306625] NET: Registered PF_PACKET protocol family [ 1.308062] Bridge firewalling registered [ 1.310289] l2tp_core: L2TP core driver, V2.0 [ 1.311140] Key type dns_resolver registered [ 1.312416] NET: Registered PF_VSOCK protocol family [ 1.332576] registered taskstats version 1 [ 1.348634] Key type .fscrypt registered [ 1.349385] Key type fscrypt-provisioning registered [ 1.358787] Btrfs loaded, zoned=no, fsverity=no [ 1.378273] Key type encrypted registered [ 1.379958] printk: legacy console [netcon0] enabled [ 1.380598] netconsole: network logging started [ 1.420133] IP-Config: Complete: [ 1.420720] device=eth0, hwaddr=52:54:00:12:34:0e, ipaddr=192.168.7.14, mask=255.255.255.0, gw=192.168.7.13 [ 1.422112] host=192.168.7.14, domain=, nis-domain=(none) [ 1.422778] bootserver=255.255.255.255, rootserver=255.255.255.255, rootpath= [ 1.422825] nameserver0=8.8.8.8 [ 1.426511] clk: Disabling unused clocks [ 1.430505] md: Waiting for all devices to be available before autodetect [ 1.431251] md: If you don't use raid, use raid=noautodetect [ 1.431899] md: Autodetecting RAID arrays. [ 1.432368] md: autorun ... [ 1.432694] md: ... autorun DONE. [ 1.478641] EXT4-fs (vda): mounted filesystem ec9c4d9d-5ace-4851-8c69-56d6804b2687 r/w with ordered data mode. Quota mode: disabled. [ 1.480200] VFS: Mounted root (ext4 filesystem) on device 253:0. [ 1.482505] devtmpfs: mounted [ 1.514197] usb 1-1: new high-speed USB device number 2 using xhci_hcd [ 1.573988] Freeing unused kernel image (initmem) memory: 2300K [ 1.575442] Run /sbin/init as init process [ 1.662555] input: QEMU QEMU USB Tablet as /devices/platform/soc/30000000.pci/pci0000:00/0000:00:02.0/usb1/1-1/1-1:1.0/0003:0627:0001.0001/input/input0 [ 1.665849] hid-generic 0003:0627:0001.0001: input: USB HID v0.01 Mouse [QEMU QEMU USB Tablet] on usb-0000:00:02.0-1/input0 INIT: version 3.14 booting [ 1.789988] usb 1-2: new high-speed USB device number 3 using xhci_hcd [ 1.930449] input: QEMU QEMU USB Keyboard as /devices/platform/soc/30000000.pci/pci0000:00/0000:00:02.0/usb1/1-2/1-2:1.0/0003:0627:0001.0002/input/input1 [ 1.986564] hid-generic 0003:0627:0001.0002: input: USB HID v1.11 Keyboard [QEMU QEMU USB Keyboard] on usb-0000:00:02.0-2/input0 Starting udev [ 2.328557] udevd[132]: starting version 3.2.14 [ 2.400915] udevd[133]: starting eudev-3.2.14 [ 2.970673] EXT4-fs (vda): re-mounted ec9c4d9d-5ace-4851-8c69-56d6804b2687 r/w. Quota mode: disabled. INIT: Entering runlevel: 5 Configuring network interfaces... ip: RTNETLINK answers: File exists Starting OpenBSD Secure Shell server: sshd generating ssh ECDSA host key... done. Starting syslogd/klogd: done Poky (Yocto Project Reference Distro) 5.2 qemuriscv64 /dev/hvc0 qemuriscv64 login: