[ 1.015481] pci 0000:00:03.0: BAR 0 [mem 0x00000000-0x00ffffff pref] [ 1.015498] pci 0000:00:03.0: BAR 2 [mem 0x00000000-0x00000fff] [ 1.015521] pci 0000:00:03.0: ROM [mem 0x00000000-0x00007fff pref] [ 1.015536] pci 0000:00:03.0: enabling Extended Tags [ 1.017341] pci 0000:00:03.0: BAR 0 [mem 0x40000000-0x40ffffff pref]: assigned [ 1.017509] pci 0000:00:03.0: ROM [mem 0x41000000-0x41007fff pref]: assigned [ 1.017593] pci 0000:00:01.0: BAR 4 [mem 0x400000000-0x400003fff 64bit pref]: assigned [ 1.017659] pci 0000:00:02.0: BAR 0 [mem 0x400004000-0x400007fff 64bit]: assigned [ 1.017697] pci 0000:00:01.0: BAR 1 [mem 0x41008000-0x41008fff]: assigned [ 1.017709] pci 0000:00:03.0: BAR 2 [mem 0x41009000-0x41009fff]: assigned [ 1.017733] pci 0000:00:01.0: BAR 0 [io 0x0020-0x003f]: assigned [ 1.017951] pci_bus 0000:00: resource 4 [io 0x0000-0xffff] [ 1.017974] pci_bus 0000:00: resource 5 [mem 0x40000000-0x7fffffff] [ 1.017983] pci_bus 0000:00: resource 6 [mem 0x400000000-0x7ffffffff] [ 1.018685] pci 0000:00:02.0: enabling device (0000 -> 0002) [ 1.024144] virtio-pci 0000:00:01.0: enabling device (0000 -> 0003) [ 1.028013] Serial: 8250/16550 driver, 4 ports, IRQ sharing disabled [ 1.040104] printk: legacy console [ttyS0] disabled [ 1.042996] 10000000.serial: ttyS0 at MMIO 0x10000000 (irq = 13, base_baud = 230400) is a 16550A [ 1.044752] printk: legacy console [ttyS0] enabled [ 1.140219] printk: legacy console [hvc0] enabled [ 1.141586] bochs-drm 0000:00:03.0: enabling device (0000 -> 0002) [ 1.150604] [drm] Found bochs VGA, ID 0xb0c5. [ 1.151429] [drm] Framebuffer size 16384 kB @ 0x40000000, mmio @ 0x41009000. [ 1.165294] [drm] Found EDID data blob. [ 1.179438] [drm] Initialized bochs-drm 1.0.0 for 0000:00:03.0 on minor 0 [ 1.253607] Console: switching to colour frame buffer device 160x50 [ 1.290032] bochs-drm 0000:00:03.0: [drm] fb0: bochs-drmdrmfb frame buffer device [ 1.321085] brd: module loaded [ 1.322217] virtio_blk virtio1: 1/0/0 default/read/poll queues [ 1.328815] virtio_blk virtio1: [vda] 701456 512-byte logical blocks (359 MB/343 MiB) [ 1.351035] xhci_hcd 0000:00:02.0: xHCI Host Controller [ 1.352630] xhci_hcd 0000:00:02.0: new USB bus registered, assigned bus number 1 [ 1.356723] xhci_hcd 0000:00:02.0: hcc params 0x00087001 hci version 0x100 quirks 0x0000000000000010 [ 1.359423] xhci_hcd 0000:00:02.0: xHCI Host Controller [ 1.359885] xhci_hcd 0000:00:02.0: new USB bus registered, assigned bus number 2 [ 1.360837] xhci_hcd 0000:00:02.0: Host supports USB 3.0 SuperSpeed [ 1.368477] hub 1-0:1.0: USB hub found [ 1.369387] hub 1-0:1.0: 4 ports detected [ 1.372727] usb usb2: We don't know the algorithms for LPM for this host, disabling LPM. [ 1.374808] hub 2-0:1.0: USB hub found [ 1.375310] hub 2-0:1.0: 4 ports detected [ 1.380090] goldfish_rtc 101000.rtc: registered as rtc0 [ 1.381592] goldfish_rtc 101000.rtc: setting system clock to 2025-07-01T22:49:58 UTC (1751410198) [ 1.385323] device-mapper: ioctl: 4.48.0-ioctl (2023-03-01) initialised: dm-devel@lists.linux.dev [ 1.389538] usbcore: registered new interface driver usbhid [ 1.390831] usbhid: USB HID core driver [ 1.391969] riscv-pmu-sbi: SBI PMU extension is available [ 1.401085] riscv-pmu-sbi: 16 firmware and 18 hardware counters [ 1.401645] riscv-pmu-sbi: Perf sampling/filtering is not supported as sscof extension is not available [ 1.406614] u32 classifier [ 1.406988] input device check on [ 1.407284] Actions configured [ 1.409545] NET: Registered PF_INET6 protocol family [ 1.417361] Segment Routing with IPv6 [ 1.417870] In-situ OAM (IOAM) with IPv6 [ 1.418817] sit: IPv6, IPv4 and MPLS over IPv4 tunneling driver [ 1.421702] NET: Registered PF_PACKET protocol family [ 1.422831] Bridge firewalling registered [ 1.424216] l2tp_core: L2TP core driver, V2.0 [ 1.425157] Key type dns_resolver registered [ 1.426409] NET: Registered PF_VSOCK protocol family [ 1.439469] registered taskstats version 1 [ 1.452450] Key type .fscrypt registered [ 1.455105] Key type fscrypt-provisioning registered [ 1.461302] Btrfs loaded, zoned=no, fsverity=no [ 1.482510] Key type encrypted registered [ 1.484966] printk: legacy console [netcon0] enabled [ 1.485740] netconsole: network logging started [ 1.532707] IP-Config: Complete: [ 1.533266] device=eth0, hwaddr=52:54:00:12:34:16, ipaddr=192.168.7.22, mask=255.255.255.0, gw=192.168.7.21 [ 1.534315] host=192.168.7.22, domain=, nis-domain=(none) [ 1.535031] bootserver=255.255.255.255, rootserver=255.255.255.255, rootpath= [ 1.535080] nameserver0=8.8.8.8 [ 1.538483] clk: Disabling unused clocks [ 1.542338] md: Waiting for all devices to be available before autodetect [ 1.543111] md: If you don't use raid, use raid=noautodetect [ 1.543952] md: Autodetecting RAID arrays. [ 1.544625] md: autorun ... [ 1.544954] md: ... autorun DONE. [ 1.594476] EXT4-fs (vda): mounted filesystem d5cbc1b9-2670-4ff9-8c7c-a5c20c0b36da r/w with ordered data mode. Quota mode: disabled. [ 1.596556] VFS: Mounted root (ext4 filesystem) on device 253:0. [ 1.599241] devtmpfs: mounted [ 1.633015] usb 1-1: new high-speed USB device number 2 using xhci_hcd [ 1.793273] input: QEMU QEMU USB Tablet as /devices/platform/soc/30000000.pci/pci0000:00/0000:00:02.0/usb1/1-1/1-1:1.0/0003:0627:0001.0001/input/input0 [ 1.797807] hid-generic 0003:0627:0001.0001: input: USB HID v0.01 Mouse [QEMU QEMU USB Tablet] on usb-0000:00:02.0-1/input0 [ 1.800499] Freeing unused kernel image (initmem) memory: 2300K [ 1.802801] Run /sbin/init as init process [ 1.920757] usb 1-2: new high-speed USB device number 3 using xhci_hcd INIT: version 3.14 booting [ 2.073837] input: QEMU QEMU USB Keyboard as /devices/platform/soc/30000000.pci/pci0000:00/0000:00:02.0/usb1/1-2/1-2:1.0/0003:0627:0001.0002/input/input1 [ 2.133995] hid-generic 0003:0627:0001.0002: input: USB HID v1.11 Keyboard [QEMU QEMU USB Keyboard] on usb-0000:00:02.0-2/input0 Starting udev [ 3.043518] udevd[134]: starting version 3.2.14 [ 3.147573] udevd[136]: starting eudev-3.2.14 [ 3.777337] EXT4-fs (vda): re-mounted d5cbc1b9-2670-4ff9-8c7c-a5c20c0b36da. INIT: Entering runlevel: 5 Configuring network interfaces... ip: RTNETLINK answers: File exists Starting OpenBSD Secure Shell server: sshd generating ssh ECDSA host key... done. Starting syslogd/klogd: done Poky (Yocto Project Reference Distro) 5.2.99+snapshot-352a7ebe2e520c3d380ab6c4a41c8a2e2c577b69 qemuriscv64 /dev/hvc0 qemuriscv64 login: